here are 2 photos... 1 to show how much I've lengthened.... the ruler i have isn't right... i think I've done around 7 cm
the second pic is of my set... I'm paranoid my right foot is twisted, but i think its ok
i apologize for the long nails,etc....
seems only one photo came out
fight for it man, don't be lazy, no pain no gain
fight for what??? lazy about what???
btw, , the photo where i show how much I've lengthened, theres a big nut thats at an angle.... now its always been like that, but last few days, if i bend my leg, the pain can be unreal... but its a pain due to possible infection or skin tearing... its really bad if i bend my knee... if i don't move, I'm ok.. ut it eels like that bolt is ripping apart the skin... idk why but its killing me now... never had this issue before.... i can't even see under it, unlike the other pin sites which ae easy to clean, this one , the frame is so close to the leg, its basically impossible to see anything
ill post a photo soon
Crimson this doesnt look to good..
I think you could possibly have avoided most of these problems if you didnt lengthen so fast and such a high ammount, and not using footholders.
At this point there is no easy way out, either take the very slow and painful road to recovery, or make the release and nail insertion and dont expect to recover as well in the end.
only lengthened around 7 cm, which in 3 months is not really that much
and the bolt was always at an angle..... i noticed it and said something the first day
if i get the release, i should be ok next week.... ill be ok as long as i can et my heels on the ground...
i agree that getting the release surgery is not the easy way out.... my tendon will be a lil weaker, but at this point, i gotta do it
medium, how long did everything take you again?
ill post a photo next
here is a photo.... it looks normal i guess... but i dnt feel normal
I think 7cm in 3 months is a lot. I spent 4 and 1/2 months lengthening to get to 7.5cm.
can't you stand?, a little bit.
you can your foot in warm salt wáter.
You must be logged in to post a reply.
